37
7.3.1 Information
The page of Information displays the MAC address of the device.
¾ Obtain an IP address automatically (DHCP): If a DHCP server is installed on the network, to
select this while the IP address is assigned by the DHCP server.
¾ Obtain DNS server address automatically: Select this to obtain the address of DNS server
automatically.
¾ Use the following IP address: Select this when the fixed IP address is set.
z IP address: Enter the IP address of the device.
z Subnet mask: Enter the subnet mask.
z Default gateway: Enter the default gateway.
¾ Use the following DNS server address: Select this when you set the fixed address as the IP
address of DNS server.
z Primary DNS server: Enter the IP address of the primary DNS server.
z Secondary DNS server: Enter the IP address of the secondary DNS server, if necessary.
¾ HTTP port number: Select 80 in general situations. If you want to use a port number other than 80,
select the text box and enter a port number between 1024 and 65535.
When you have set the HTTP port number to a number other than 80 on the Network setting page
or in the Setup Program, access the device by typing the IP address of the device on the web
browser as follows: for example, when HTTP port number is set to 2000 and the IP address of your
camera is set to 192.168.1.100, you should type in http://192.168.1.100:2000/
to access the device.
)
Note:
1. The IP Camera needs to be rebooted after it finishes changing the network setting completely.
Please go to “Setting→ Basic → System → Initialize” page and click the Reboot button after
you make some changes.
To Next Page
Loading...
