11
Mode
Accessing
Path
Prompt
Logout or Access the next
mode
Interface
Configuration
Mode
Use the interface
type number
command to enter
this mode from
Global
Configuration
Mode.
TL-SG2008 (config-if)#
or
TL-SG2008(config-if-range)#
Use the end command or press
Ctrl+Z to return to Privileged EXEC
Mode.
Enter exit command or the #
command to return to Global
Configuration Mode.
A port number must be specified in
the interface command.
VLAN
Configuration
Mode
Use the vlan
vlan-list command
to enter this mode
from Global
Configuration
Mode.
TL-SG2008 (config-vlan)#
Use the end command or press
Ctrl+Z to return to Privileged EXEC
Mode.
Enter the exit command or the #
command to return to Global
configuration Mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a Telnet/SSH connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as the
Spanning Tree, Schedule Mode and so on.
Interface Configuration Mode: In this mode, users can configure one or several ports,
different ports corresponds to different commands
a). Interface gigabitEthernet: Configure parameters for a Gigabit Ethernet port, such as
Duplex-mode, flow control status.
b). Interface range gigabitEthernet: Configure parameters for several Gigabit Ethernet
ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface vlan: Configure parameters for the vlan-port.
Vlan Configuration Mode: In this mode, users can create a VLAN and add a specified
port to the VLAN.
To Next Page
Loading...
