TP-Link TL-SG2216 - Ipv6 Mld Snooping Unknown-Filter; Ipv6 Mld Snooping Last-Listener Query-Inteval

ipv6 mld snooping unknown-filter
Description
The ipv6 mld snooping unknown-filter command is used to enable the
unknown multicast packets filter function. To disable this function, please use no
ipv6 mld snooping unknown-filter command. By default, it is disabled.
Syntax
ipv6 mld snooping unknown-filter
no ipv6 mld snooping unknown-filter
Command Mode
Global Configuration Mode
Example
Enable unknown multicast filter function:
TL-SG2424(config)# ipv6 mld snooping unknown-filter
ipv6 mld snooping last-listener query-inteval
Description
The ipv6 mld snooping last-listener query-inteval command is used to
specify the interval to send Specific Query Message. The default value is 1
second. To restore the default interval, please use no ipv6 mld snooping
last-listener query-inteval command.
Syntax
ipv6 mld snooping last-listener query-inteval interval
no ipv6 mld snooping last-listener query-inteval
Parameter
interval —— Specify the interval to send Specific Query Message in seconds,
ranging from 1 to 5.
Command Mode
Global Configuration Mode
Example
Specify the interval of Specific Query Message to 3 seconds:
TL-SG2424(config)# ipv6 mld snooping last-listener query-inteval 3
171