TP-Link TL-SG2424P - Page 15

5
Mode Accessing Path Prompt
Logout or Access the next
mode
User EXEC
Mode
Primary mode once it
is connected with the
switch.
TL-SG2424P>
Use the exit command to
disconnect the switch.
Use the enable command to
access Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to enter
this mode from User
EXEC mode.
TL-SG2424P#
Enter the disable or the exit
command to return to User EXEC
mode.
Enter configure command to
access Global Configuration
mode.
Global
Configuration
Mode
Use the configure
command to enter
this mode from
Privileged EXEC
mode.
TL-SG2424P(config)#
Use the exit or the end command
or press Ctrl+Z to return to
Privileged EXEC mode.
Use the interface
gigabitEthernet port or interface
range gigabitEthernet port-list
command to access interface
Configuration mode.
Use the vlan vlan-list to access
VLAN Configuration mode.
Interface
Configuration
Mode
Use the interface
gigabitEthernet port
or interface range
gigabitEthernet
port-list command to
enter this mode from
Global Configuration
mode.
TL-SG2424P(config-if)#
or
TL-SG2424P(config-if-range)#
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global Configuration
mode.
A port number must be specified
in the interface command.
VLAN
Configuration
Mode
Use the vlan vlan-list
command to enter
this mode from
Global Configuration
mode.
TL-SG2424P(config-vlan)#
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global configuration
mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and
the switch is established by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.
 Global Configuration Mode: In this mode, global commands are provided, such as
the Spanning Tree, Schedule Mode and so on.
 Interface Configuration Mode: In this mode, users can configure one or several
ports, different ports corresponds to different commands