User Guide 414
Configuring Layer 3 Interfaces Configuration Example
Switch(config)#vlan 2
Switch(config-vlan)#exit
Switch(config)#interface gigabitEthernet 1/0/2
Switch(config-if)#switchport general allowed vlan 2 untagged
Switch(config-if)#exit
2) Create VLAN interface 2 for VLAN 2. Configure the IP address of VLAN interface 2 as
192.168.2.1.
Switch(config)#interface vlan 2
Switch(config-if)#ip address 192.168.2.1 255.255.255.0
Switch(config-if)#end
Switch#copy running-config startup-config
Verify the VLAN Interface Configurations
Verify the configurations of VLAN interface 2.
Switch#show interface vlan 2
VLAN2 is down, line protocol is down
Hardware is CPU Interface, address is 00:0a:eb:13:a2:98
ip is 192.168.2.1/24
To Next Page
Loading...
