Section 9. IP Addressing Commands
ip address
The ip address Interface Configuration (Ethernet, VLAN, port-channel) mode command sets an IP address. To
remove an IP address, use the no form of this command.
Syntax
ip address ip-address {mask | prefix-length}
no ip address [ip-address]
Parameters
•
ip-address —Valid IP address
• mask — Valid network mask of the IP address.
• prefix-length — Specifies the number of bits that comprise the IP address prefix. The prefix length must be
preceded by a forward slash (/). (Range: 8 -30)
Default Configuration
No IP address is defined for interfaces.
Command Mode
Interface Configuration (Ethernet, VLAN, port-channel) mode
User Guidelines
An IP address cannot be configured for a range of interfaces (range context).
Example
The following example configures VLAN 1 with IP address 131.108.1.27 and subnet mask 255.255.255.0.
Console(config)#
interface vlan
1
Console(config-if)#
ip address
131.108.1.27 255.255.255.0
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
To Next Page
Loading...
