permit (Management)
The permit Management Access-List Configuration mode command defines a permit rule.
Syntax
permit [ethernet interface-number | vlan vlan-id | port-channel port-channel-number]
permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel
port-channel-number]
Parameters
•
interface-number — A valid Ethernet port number.
• vlan-id — A valid VLAN number.
• port-channel-number — A valid port channel index.
• ip-address — A valid source IP address.
• mask — A valid network mask of the source IP address.
• prefix-length — Number of bits that comprise the source IP address prefix. The prefix length must be pre-
ceded by a forward slash (/). (Range: 0 - 32)
Default Configuration
If no permit rule is defined, the default is set to deny.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the appropri-
ate interface.
The system supports up to 128 management access rules.
Example
The following example permits all ports in the mlist access list.
Console(config)#
management access-list
mlist
Console(config-macl)#
permit
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
To Next Page
Loading...
