TP-Link TL-SG3109 - Radius-Server Source-Ip

radius-server source-ip
The radius-server source-ip Global Configuration mode command specifies the source IP address used for
communication with RADIUS servers. To return to the default configuration, use the no form of this command.
Syntax
radius-server source-ip source
no radius-source-ip source
Parameters
•
source — Specifies a valid source IP address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS servers to
10.1.1.1.
console(config)# radius-server source-ip 10.1.1.1
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
Page 176