show interfaces status
The show interfaces status Privileged EXEC mode command displays the status of all configured interfaces.
Syntax
show interfaces status [ethernet interface| port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port. (Full syntax: port)
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status of all configured interfaces:
Console#
show interfaces status
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
Back
Pressure
Mdix
Mode
---- ----------- ------ ----- ------- ---- ----- -------- ----
1 100M-Copper -- -- -- -- Down -- --
2 100M-Copper -- -- -- -- Down -- --
3 100M-Copper -- -- -- -- Down -- --
4 100M-Copper -- -- -- -- Down -- --
5 100M-Copper Full 100 Enabled Off Up Disabled Auto
6 100M-Copper -- -- -- -- Down -- --
7 100M-Copper -- -- -- -- Down -- --
8 100M-Copper -- -- -- -- Down -- --
9 1G-Copper -- -- -- -- Down -- --
10 1G-Fiber -- -- -- -- Down -- --
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
---- ----------- ------ ----- ------- ---- -----
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
To Next Page
Loading...
