hostname
Description
The hostname command is used to configure the system name. To clear the
system name information, please use no hostname command.
Syntax
hostname hostname
no hostname
Parameter
hostname —— System Name. The length of the name ranges from 1 to 32
characters. By default, it is the device name, for example “TL-SG3424”.
Command Mode
Global Configuration Mode
Example
Configure the system name as TPLINK:
TL-SG3424(config)# hostname TPLINK
location
Description
The location command is used to configure the system location. To clear the
system location information, please use no location command.
Syntax
location location
no location
Parameter
location —— Device Location. It consists of 32 characters at most. It is
“SHENZHEN” by default.
Command Mode
Global Configuration Mode
Example
Configure the system location as SHENZHEN:
TL-SG3424(config)# location SHENSHEN
119
To Next Page
Loading...
