contact-info
Description
The contact-info command is used to configure the system contact information.
To clear the system contact information, please use no contact-info command.
Syntax
contact-info contact_info
no contact-info
Parameter
contact_info —— Contact Information. It consists of 32 characters at most. It is
“www.tp-link.com” by default.
Command Mode
Global Configuration Mode
Example
Configure the system contact information as www.tp-link.com:
TL-SG3424(config)# contact-info www.tp-link.com
ip management-vlan
Description
The ip management-vlan command is used to configure the management
VLAN, through which you can log on to the switch. By default, the management
VLAN is VLAN1.
Syntax
ip management-vlan {vlan-id}
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode
Example
Set the VLAN6 as management VLAN:
TL-SG3424(config)# ip management-vlan 6
120
To Next Page
Loading...
