server. To delete the allocated IP from DHCPv6 server and disable the DHCPv6
Client function, please use no ipv6 address dhcp command.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Configuration Mode
Interface Configuration Mode (interface vlan)
Example
Enable the DHCP Client function when the management VLAN of the switch is
VLAN1:
TL-SG3424(config)# interface vlan 1
TL-SG3424(config-if)# ipv6 address dhcp
ipv6 address ra
Description
This command is used to configure the switch’s global IPv6 address according to
the address prefix and other configuration parameters from its received
RA(Router Advertisement) message. To disable this function, please use no
ipv6 address ra command.
Syntax
ipv6 address ra
no ipv6 address ra
Configuration Mode
Interface Configuration Mode (interface vlan)
Example
Enable the automatic ipv6 address configuration function to obtain IPv6 address
through the RA message when the management VLAN of the switch is VLAN1:
TL-SG3424(config)# interface vlan 1
TL-SG3424(config-if)# ipv6 address ra
133
To Next Page
Loading...
