TP-Link TL-SG3210 - Chapter 10 PoE; 10.1 PoE Config

Syntax
media-type { rj45 | sfp }
Parameter
rj45 | sfp —— Media type.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the media type of Combo port 24T as “SFP”:
TL-SG3424(config)# interface gigabitEthernet 1/0/24
TL-SG3424(config-if)# media-type sfp
duplex
Description
The duplex command is used to configure the Duplex Mode for an Ethernet port.
To return to the default configuration, please use no duplex command.
Syntax
duplex { full | half }
no duplex
Parameter
full | half —— The duplex mode of the Ethernet port. There are two options:
full-duplex mode (default) and half-duplex mode.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Duplex Mode as full-duplex for port 3:
TL-SG3424(config)# interface gigabitEthernet 1/0/3
TL-SG3424(config-if)# duplex full
139