speed
Description
The speed command is used to configure the Speed Mode for an Ethernet port.
To return to the default configuration, please use no speed command.
Syntax
speed { 10 | 100 | 1000 | auto }
no speed
Parameter
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are four
options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode (default).
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Speed Mode as 100Mbps for port 3:
TL-SG3424(config)# interface gigabitEthernet 1/0/3
TL-SG3424(config-if)# speed 100
storm-control broadcast
Description
The storm-control broadcast command is used to enable the broadcast control
function. To disable the broadcast control function, please use no storm-control
broadcast command. Broadcast control function allows the switch to filter
broadcast in the network. If the transmission rate of the broadcast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
Syntax
storm-control broadcast [ rate rate ]
no storm-control broadcast
Parameter
rate —— Specify the bandwidth for receiving broadcast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. The value of it can be
128k | 256k | 512k | 1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default,
the value is “128K”.
140
To Next Page
Loading...
