TP-Link TL-SG3210 - Redirect Vlan; S-Condition

Example
Edit the actions for policy1. Forward the data packets matching ACL 120 in the
policy to port 2:
TL-SG3424(config)# access-list policy action policy1 120
TL-SG3424(config-action)# redirect interface gigabitEthernet 1/0/2
redirect vlan
Description
The redirect vlan command is used to configure Direction function of policy
action for specified VLAN.
Syntax
redirect vlan vlan-id
Parameter
vlan-id —— The VLAN ID of Redirect. The data packets matching the corresponding
ACL will be forwarded in the specific VLAN. The VLAN ID ranges from 1 to 4094.
Command Mode
Action Configuration Mode
Example
Edit the actions for policy1. Forward the data packets matching ACL 120 in the
policy to Fast Ethernet VLAN 1:
TL-SG3424(config)# access-list policy action policy1 120
TL-SG3424(config-action)# redirect vlan 1
s-condition
Description
The s-condition command is used to configure Stream Condition function of
policy action.
Syntax
s-condition rate rate osd { none | discard }
Parameter
rate —— The rate of Stream Condition, ranging from 0 to 100000kbps.
185