Chapter 27 MSTP Commands
MSTP (Multiple Spanning Tree Protocol), compatible with both STP and RSTP and subject to IEEE
802.1s, can disbranch a ring network. STP is to block redundant links and backup links as well as
optimize paths.
spanning-tree(global)
Description
The spanning-tree command is used to enable STP function globally. To disable
the STP function, please use no spanning-tree command.
Syntax
spanning-tree
no spanning-tree
Command Mode
Global Configuration Mode
Example
Enable the STP function:
TL-SG3424(config)# spanning-tree
spanning-tree(interface)
Description
The spanning-tree command is used to enable STP function for a port. To
disable the STP function, please use no spanning-tree command.
Syntax
spanning-tree
no spanning-tree
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the STP function for port 2:
TL-SG3424(config)# interface gigabitEthernet 1/0/2
191
To Next Page
Loading...
