leave-time —— Leave Time, which is the interval between the switch receiving a
leave message from a host and the switch removing the host from the multicast
groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
port —— The Ethernet port number.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds,
Member Port Time 100 seconds, Leave Time 3 seconds, and Static Router Port
port 3:
TL-SG3424(config)# ip igmp snooping multi-vlan-config 3 rtime 100
TL-SG3424(config)# ip igmp snooping multi-vlan-config 3 mtime 100
TL-SG3424(config)# ip igmp snooping multi-vlan-config 3 ltime 3
TL-SG3424(config)# ip igmp snooping multi-vlan-config 3 rport interface
gigabitEthernet 1/0/3
ip igmp snooping filter add-id
Description
The ip igmp snooping filter add-id command is used to configure the multicast
IP-range desired to filter. To delete the corresponding IP-range, please use no ip
igmp snooping filter add-id command. When IGMP Snooping is enabled, you
can specified the multicast IP-range the ports can join so as to restrict users
ordering multicast programs via configuring multicast filter rules. Multicast IP
addresses ranges from 224.0.0.0 to 239.255.255.255. The range for receivers to
join is from 224.0.1.0 to 239.255.255.255.
Syntax
ip igmp snooping filter addr-id addr-id list
no ip igmp snooping filter addr-id addr-id list
Parameter
addr-id list —— The filtering address ID to be bound.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
211
To Next Page
Loading...
