TP-Link TL-SG3210 - 1.1.4 Logon by SSH

3. You are prompted to enter the connection password 456 you have set through Console port
connection, and then you are in User EXEC Mode.
Figure 1-11 Enter into the User EXEC Mode
4. Type enable command to enter Privileged EXEC Mode.
Figure 1-12 Enter into the Privileged EXEC Mode
Now you can manage your switch with CLI commands through Telnet connection.
Note:
You can refer to Chapter 9 User Manage Commands for detailed commands information of the
Telnet connection configuration.
1.1.4 Logon by SSH
To log on by SSH, a Putty client software is recommended. There are two authentication modes to
set up an SSH connection:
Password Authentication Mode: It requires username and password, which are both admin by
default.
Key Authentication Mode: It requires a public key for the switch and a private key for the SSH
client software. You can generate the public key and the private key through Putty Key Generator.
Note:
Before SSH login, please follow the steps shown in Figure 1-13 to enable the SSH function through
Telnet connection.
9