TP-Link TL-SG3210 - Cluster Explore; Cluster

request packets over. NTDP Port Delay ranges from 1 to 100 in milliseconds. By
default, it is 20.
hop-value —— NTDP Hops, which is the hop count the switch topology collects.
NTDP Hops ranges from 1 to 16. By default, it is 3.
Command Mode
Global Configuration Mode
Example
Enable NTDP function globally, and specify NTDP Hops as 5, NTDP Interval
Time as 30 minutes:
TL-SG3424(config)# cluster ntdp
TL-SG3424(config)# cluster ntdp timer interval-timer 30
TL-SG3424(config)# cluster ntdp hop 5
cluster explore
Description
The cluster explore command is used to manually collect the topology
information.
Syntax
cluster explore
Command Mode
Global Configuration Mode
Example
Enable the topology information collecting function manually:
TL-SG3424(config)# cluster explore
cluster
Description
The cluster command is used to configure cluster function for specified ports. To
return to the default configuration, please use no cluster command.
Syntax
cluster [ ndp { disable | enable }] [ ntdp { disable | enable }]
no cluster
267