TP-Link TL-SG3210 - Cluster Candidate; Cluster Individual

Parameter
disable | enable —— Enable/ Disable NDP function for the port. By default, it is
enabled.
disable | enable —— Enable/ Disable NTDP function for the port. By default, it is
enabled.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable NDP and NTDP function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# cluster ndp enable ntdp enable
cluster candidate
Description
The cluster candidate command is used to specify the current switch as
candidate switch.
Syntax
cluster candidate
Command Mode
Global Configuration Mode
Example
Specify the current switch as candidate switch:
TL-SG3424(config)# cluster candidate
cluster individual
Description
The cluster individual command is used to specify the current switch as
individual switch.
Syntax
cluster individual
Command Mode
Global Configuration Mode
268