Configure the timeout time of the HTTP connection as 15 minutes:
TL-SG3424(config)# ip http session 15
ip http secure-server
Description
The ip http secure-server command is used to enable the HTTPS server within
the switch. To disable the HTTPS function, please use no ip http secure-server
command. This function is enabled by default. The HTTP and HTTPS server
function cannot be disabled at the same time.
Syntax
ip http secure-server
no ip http secure-server
Command Mode
Global Configuration Mode
Example
Disable the HTTP function:
TL-SG3424(config)# no ip http secure-server
ip http secure-protocol
Description
The ip http secure-protocol command is used to configure the SSL protocol
version. To restore to the default SSL version, please use no ip http
secure-protocol command. By default, the switch supports SSLv3 and TLSv1.
Syntax
ip http secure-protocol { [ ssl3 ] [ tls1 ] }
no ip http session
Parameter
ssl3 —— The SSL 3.0 protocol.
tls1 —— The TLS 1.0 protocol
Command Mode
Global Configuration Mode
63
To Next Page
Loading...
