21
L2 Managed Switch
Figure 5-7 Port Settings
6. Type the User name and Password in the Hyper Terminal window, the factory default
value for both of them is admin. The DOS prompt” TP-LINK>” will appear after
pressing the Enter button as Figure 5-8 shown. It indicates that you can use the CLI
now.
Figure 5-8 Log in the Switch
■
Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. Make sure the switch and the PC are in the same LAN.
2. Click Start
→
Run to open the Run window.
Configuration
To Next Page
Loading...
