Please connect the Ethernet ports of the Switch to the network devices by RJ45 cable
as the following figure shown.
RJ45 Port
RJ45 Cable
Connecting the RJ45 PortFigure 4-1
Connect the SFP port to a SFP module. For the Switch, if an SFP transceiver (purchased
separately) is installed in a slot and has a valid link on the port, the associated RJ45
port will be disabled and cannot be used.
SFP Port
Connecting the LAN PortFigure 4-2
Note: SFP module supports hot-plugging, plug the SFP module into the SFP port
and the Switch can identify it automatically. The SFP port must connect to 1000Mbps
device.
Connection
SFP Module
To Next Page
Loading...
