VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
110
engct"nqiikpi"
Fguetkrvkqp"
The"engct nqiikpi command is used to clear the information in the log buffer
and log file.
U{pvcz"
engct nqiikpi"[ buffer | flash ]"
Rctcogvgt"
buffer | flash —The output channels: buffer and flash. Clear the information of
the two channels, by default.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Clear the information in the log file:
VN/UN764:G*eqphki+%engct nqiikpi buffer"
nqiikpi"jquv"kpfgz"
Fguetkrvkqp"
The"nqiikpi"jquv"kpfgz command is used to configure the Log Host. To clear
the configuration of the specified Log Host, please use"pq"nqiikpi"jquv"kpfgz
command. Log Host is to receive the system log from other devices. You can
remotely monitor the settings and operation status of other devices through the
log host.
U{pvcz"
nqiikpi"jquv"kpfgz"idx host-ip level
pq"nqiikpi"jquv"kpfgz idx
Rctcogvgt"
idx ——The index of the log host. The switch supports 4 log hosts.
host-ip —— The IP for the log host.
level ——The severity level of the log information sent to each log host. There
are 8 severity levels marked with values 0-7. The smaller value has the higher
To Next Page
Loading...
