VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
112
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Gzcorng"
Display the configuration of the log host 2:
VN/UN764:G*eqphki+%ujqy"nqiikpi"nqijquv"2"
ujqy"nqiikpi"dwhhgt"
Fguetkrvkqp"
The ujqy"nqiikpi"dwhhgt command is used to display the log information in the
log buffer according to the severity level.
U{pvcz"
ujqy"nqiikpi"dwhhgt"[ngxgn level]
Rctcogvgt"
level —— Severity level. There are 8 severity levels marked with values 0-7.
The information of levels with priority not lower than the select level will display.
Display all the log information in the log buffer by default.
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Gzcorng"
Display the log information from level 0 to level 5 in the log buffer:
VN/UN764:G*eqphki+%ujqy"nqiikpi"dwhhgt"ngxgn 5"
ujqy"nqiikpi"hncuj"
Fguetkrvkqp"
The ujqy"nqiikpi"hncuj command is used to display the log information in the
log file according to the severity level.
U{pvcz"
ujqy"nqiikpi"hncuj"[ngxgn level]
Rctcogvgt"
To Next Page
Loading...
