VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
136
Gzcorng"
Enable the DHCP Client function when the management VLAN of the switch is
VLAN1:
VN/UN764:G*eqphki+%"kpvgthceg"xncp"1"
VN/UN764:G*eqphki/kh+%"kr"cfftguu/cnnqe"fjer"
kr"cfftguu/cnnqe"dqqvr"
Fguetkrvkqp"
The"kr"cfftguu/cnnqe"dqqvr"command is used to enable the BOOTP Protocol.
When the BOOTP Protocol is enabled, the switch will obtain IP address from
BOOTP Server. This command should be configured in the Interface
Configuration Mode of the management VLAN.
U{pvcz"
kr"cfftguu/cnnqe"dqqvr"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface vlan)"
Gzcorng"
Enable the BOOTP Protocol to obtain IP address from BOOTP Server when the
management VLAN of the switch is VLAN1:
VN/UN764:G*eqphki+%"kpvgthceg"xncp"1"
VN/UN764:G*eqphki/kh+%"kr"cfftguu/cnnqe"dqqvr"
tgugv"
Fguetkrvkqp"
The tgugv"command is used to reset the switch’s software. After resetting, all
configuration of the switch will restore to the factory defaults and your current
settings will be lost.
U{pvcz"
tgugv"
Eqoocpf"Oqfg"
Privileged EXEC Mode
To Next Page
Loading...
