VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
156
VN/UN764:G*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN764:G*eqphki/kh+%fwrngz full"
urggf"
Fguetkrvkqp"
The"urggf"command is used to configure the Speed Mode for an Ethernet port.
To return to the default configuration, please use pq"urggf"command."
U{pvcz"
urggf { 10 | 100 | 1000 | auto }"
pq"urggf"
Rctcogvgt
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are
four options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode
(default).
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure the Speed Mode as 100Mbps for Gigabit Ethernet port 25:
VN/UN764:G*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN764:G*eqphki/kh+%urggf 100"
uvqto/eqpvtqn"dtqcfecuv"
Fguetkrvkqp"
The" uvqto/eqpvtqn" dtqcfecuv" command is used to enable the broadcast
control function. To disable the broadcast control function, please use pq"
uvqto/eqpvtqn" dtqcfecuv" command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth, the packets will be automatically discarded
to avoid network broadcast storm.
U{pvcz"
uvqto/eqpvtqn dtqcfecuv"[tcvg rate]
pq"uvqto/eqpvtqn"dtqcfecuv" "
To Next Page
Loading...
