TP-Link TL-SL5428E - clear counters; show interface status

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
159
pq"dcpfykfvj"{ all | ingress | egress }"
Rctcogvgt
ingress-rate ——Specify the bandwidth for receiving packets. Range: 1-100000
for the megaport, 1-1000000 for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:1-100000
for the megaport, 1- 1000000 for the gigaport.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for Fast
Ethernet port 5:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/5
VN/UN764:G*eqphki/kh+%dcpfykfvj"kpitguu 5120 gitguu 1024"
engct"eqwpvgtu"
Fguetkrvkqp"
The engct"eqwpvgtu"command is used to clear the statistic information of all the
Ethernet ports."
U{pvcz"
engct"eqwpvgtu
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Clear the statistic information of all Ethernet ports
VN/UN764:G*eqphki+%engct"eqwpvgtu"
ujqy"kpvgthceg"uvcvwu"
Fguetkrvkqp"
The ujqy"kpvgthceg"uvcvwu"command is used to display the connective-status
of an Ethernet port.