VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
204
urcppkpi/vtgg"ouv"
Fguetkrvkqp"
The urcppkpi/vtgg"ouv command is used to configure MST Instance Port. To
return to the default configuration of the corresponding Instance Port, please
use"pq urcppkpi/vtgg"ouv"command. A port can play different roles in different
spanning tree instance. You can use this command to configure the parameters
of the ports in different instance IDs as well as view status of the ports in the
specified instance
U{pvcz"
urcppkpi/vtgg"ouv"kpuvcpeg instance-id { [rqtv/rtkqtkv{ pri] [equv cost] }
pq"urcppkpi/vtgg"ouv"kpuvcpeg instance-id"
Rctcogvgt"
instance-id —— Instance ID, ranging from 1 to 8.
pri —— Port Priority, which must be multiple of 16 ranging from 0 to 240. By
default, it is 128. Port Priority is an important criterion on determining if the port
will be chosen as the root port by the device connected to this port.
cost —— Path Cost, ranging from 0 to 200000. The lower value has the higher
priority. Its default value is 0 meaning “auto”.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure the priority of Fast Ethernet port 1 in MST Instance 1 as 64, and path
cost as 2000:"
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv 1/0/1
VN/UN764:G*eqphki/kh+%urcppkpi/vtgg" ouv" kpuvcpeg" 1"rqtv/rtkqtkv{" 64"equv
2000
urcppkpi/vtgg"rtkqtkv{"
Fguetkrvkqp"
The urcppkpi/vtgg"rtkqtkv{"command is used to configure the bridge priority. To
return to the default value of bridge priority, please use pq" urcppkpi/vtgg"
rtkqtkv{ command.
To Next Page
Loading...
