VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
236
leave-time —— Leave Time, which is the interval between the switch receiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
port —— Static Router Port, which is mainly used in the network with stable
topology. There are two types of port: Fast Ethernet port, ranging from 1 to 24, in
the format of 1/0/2; Gigabit Ethernet port, ranging from 25 to 28, in the format of
1/0/25.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds:
VN/UN764:G*eqphki+%kr"kior"upqqrkpi"ownvk/xncp/eqphki"3 tvkog"100
kr"kior"upqqrkpi"hknvgt"cff/kf"
Fguetkrvkqp"
The kr" kior" upqqrkpi" hknvgt" cff/kf" command is used to configure the
multicast IP-range desired to filter. To delete the corresponding IP-range, please
use pq" kr" kior" upqqrkpi" hknvgt" cff/kf command. When IGMP Snooping is
enabled, you can specified the multicast IP-range the ports can join so as to
restrict users ordering multicast programs via configuring multicast filter rules.
Multicast IP addresses ranges from 224.0.0.0 to 239.255.255.255. The range
for receivers to join is from 224.0.1.0 to 239.255.255.255.
U{pvcz"
kr"kior"upqqrkpi"hknvgt"cfft/kf"addr-id list
pq"kr"kior"upqqrkpi"hknvgt"cfft/kf"addr-id list"
Rctcogvgt"
addr-id list —— The filtering address ID to be bound.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Bind the filtering address ID 2-6 to Fast Ethernet port 3:
VN/UN764:G*eqphki+%kpvgthceg hcuvGvjgtpgv"1/0/3
VN/UN764:G*eqphki/kh+%kr"kior"upqqrkpi"hknvgt"cfft/kf"2-6"
To Next Page
Loading...
