VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
241
kr"kior"upqqrkpi"swgtkgt"xncp"*urgekhke"swgt{+"
Fguetkrvkqp"
The kr" kior" upqqrkpi" swgtkgt" xncp command is used to configure the
parameters for IGMP Snooping Querier to send a specific query frame. To
return to the default configuration, please use pq" kr" kior"upqqrkpi" swgtkgt"
xncp"command.
U{pvcz"
kr"kior"upqqrkpi"swgtkgt"xncp"vlan-list"{ncuv/ogodgt/swgt{/kpvgtxcn"interval
|"ncuv/ogodgt/swgt{/eqwpv count | urgekcn/swgt{"uqwteg/kr"ip-addr }
pq" kr" kior" upqqrkpi" swgtkgt" xncp" vlan-list" {ncuv/ogodgt/swgt{/kpvgtxcn" |"
ncuv/ogodgt/swgt{/eqwpv |"urgekcn/swgt{"uqwteg/kr}
Rctcogvgt"
vlan-list—— VLAN ID list, ranging from 1 to 4094, in the format of 1-3, 5. It is
multi-optional.
interval—— The time interval of sending specific query frames by IGMP
Snooping Querier, ranging from 1 to 5 (Seconds). By default, it is 1. A specific
query will be sent on condition that “immediate-leave” is not enabled and a
leave frame is received.
count—— The times of sending specific query frames by IGMP Snooping
Querier, ranging from 1 to 5. By default, it is 2. The switch will still treat the port
as group member until the specific frames number sent by the querier reaches
“last-member-query-count” and no report frame is received from the port.
ip-addr—— The source IP of the specific query frame sent by IGMP Snooping
Querier. It should not be a multicast IP or a broadcast IP. By default, it is
192.168.0.1.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
For VLAN 2, specify its last-member-query-interval as 2:
VN/UN764:G*eqphki+%kr" kior" upqqrkpi" swgtkgt" xncp" 2
ncuv/ogodgt/swgt{/kpvgtxcn 2"
To Next Page
Loading...
