TP-Link TL-SL5428E - show dot1 q-tunnel mapping interface; show dot1 q-tunnel uplink

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
42
ujqy"fqv3s/vwppgn"ocrrkpi"kpvgthceg"
Fguetkrvkqp"
The ujqy" fqv3s/vwppgn" ocrrkpi" kpvgthceg command is used to display the
VLAN Mapping port enable state of VLAN Mapping"
U{pvcz"
ujqy"fqv3s/vwppgn"ocrrkpi"kpvgthceg"
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Gzcorng"
Display the enable state of all VLAN Mapping ports:
VN/UN764:G*eqphki+%ujqy"fqv3s/vwppgn"ocrrkpi"kpvgthceg"
ujqy"fqv3s/vwppgn"wrnkpm"
Fguetkrvkqp"
The ujqy"fqv3s/vwppgn"wrnkpm command is used to display the configuration
information of the VLAN VPN Up-link ports.
U{pvcz"
ujqy"fqv3s/vwppgn"wrnkpm"
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Gzcorng"
Display the configuration information of the VLAN VPN Up-link ports:
VN/UN764:G*eqphki+%"ujqy"fqv3s/vwppgn"wrnkpm