23
Chapter 3
Customize Your Network
• When you choose Smart IP (DHCP) in Network > LAN, the DHCP Server settings will be disabled.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to DHCP > DHCP Settings and select Enable.
3. Enter the Start IP Address and End IP Address, and leave other parameters as the
default settings.
4. Click Save.
3. 9. 2. DHCP Clients List
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to DHCP > DHCP Clients List to view the information of the clients connected to
the access point. You cannot change any of the values on this page. To update this
page and show the current attached devices, click Refresh.
3. 9. 3. Address Reservation (Access Point mode)
You can reserve an IP address for a specific client. When you specify a reserved IP
address for a PC on the LAN, this PC will always receive the same IP address each time
when it accesses the DHCP server.
1. Visit http://tplinkwifi.net, and log in with the password you set for the access point.
2. Go to DHCP > Address Reservation and click Add New.
To Next Page
Loading...
