30
Chapter 4
Manage Your Access Point
Note:
• Make sure the latest firmware file is matched with the hardware version (as shown in the download
section of the Support page).
• Make sure that you have a stable connection between the access point and your computer. It is NOT
recommended to upgrade the firmware wirelessly.
• Backup your access point configuration.
• Do NOT power off the access point during the firmware upgrade.
1. Download the latest firmware file for the access point from our website www.tp-link.
com.
2. Visit http://tplinkap.net, and log in with the password you set for the access point.
3. Go to System Tools > Firmware Upgrade.
4. Click Choose File to locate the downloaded firmware file, and click Upgrade.
5. Wait a few minutes for the firmware upgrade to complete and the access point to
reboot.
4. 6. Factory Defaults
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to System Tools > Factory Defaults. Click Restore to reset all settings to the
default values.
4. 7. Backup & Restore
The configuration settings are stored as a configuration file in the access point. You can
back up the configuration file in your computer for future use and restore the access
point to the previous settings from the backup file when needed.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to System Tools > Backup & Restore.
To Next Page
Loading...
