TP-Link TL-WA801ND - Page 2


8.
Find your wireless network, and chooseConnect.
9.
Enter the wireless network password and choose Next.

10.
If DHCP service is on the wireless network, leave the Type asSmart IP (DHCP)and
chooseNext.


11.
Verify the settings that are chosen, and choose Finish.
The access point has been configured and the eGauge may be connected via Ethernet for network
communication.

I cannot reach the eGauge on the proxy server or locally.
Verify the TP-Link access point is powered up and configured. Connect a laptop to the Ethernet
port on the TP-Link access point, disable WiFi, bluetooth and any other wireless network interfaces
and try reaching the internet.
I don't see my network listed in the quick setup network list, or the signal is weak or
inconsistent.
Ensure the two antennas are secured on the back of the unit and that the wireless network is
within range of the access point.
I do not have network access through the TP-Link access point, or the network information
has changed and I cannot access the configuration interface.
Perform a factory reset on the TP-Link access point by using a paperclip or pin and holding down
the recessed reset button on the back of the unit, release the button when all the LEDs turn off or
flash. Then, re-configure the unit using the steps in this article.
Troubleshooting
Revision #2
Created Fri, Jan 31, 2020 10:15 PM by Andrew