TL-WR702N 150Mbps Wireless N Nano Router
- 19 -
3.2.3 Repeater Mode
When you choose Repeater Mode on Working Mode page in Figure 3-5 , take the following
steps:
1. Click Next, and then Wireless Repeater page will appear as shown in Figure 3-15.
Figure 3-15 Quick Setup - Wireless Repeater
¾ SSID - The SSID of AP that you want to access.
¾ MAC of AP - The MAC address of AP that you want to access.
¾ Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the Router can be used. It may be illegal to use the wireless function of
the Router in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
¾ Survey - Click this button, you can search the AP which runs in the environment.
¾ Security Options - This option should be chosen according to the security configuration of
the AP you want to access. It is recommended that the security type is the same as your AP’s
security type.
¾ WEP Key Index - This option should be chosen if the key type is WEP (ASCII) or WEP (HEX).
It indicates the index of the WEP key.
¾ Authentication Type - This option should be chosen if the key type is WEP (ASCII) or WEP
(HEX). It indicates the authentication type of the Root AP.
¾ Password - If the AP your router is going to connect need password, you need to fill the
password in this blank.
To Next Page
Loading...
