TQC LD0800 - Page 9

9
t %FMFUFXIPMFHSPVQSFBEJOHT
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Delete Data”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate “Current Group”, and press “Left Key” once.
A dialog box will be displayed.
d. Press “Left Key” once to conrm the selection and go back, or “Right Key” to cancel and go
back. Press “ZERO Key” to go back to measuring mode.
t 3FDBMMBOEEFMFUFTQFDJöFESFBEJOHT
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Recall”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to recall the readings (n/Total number, “n” indicates the index
of current shown readings). User can press “Left Key” to delete current shown readings.
d. Press “Right Key” to go back. Press “ZERO Key” to go back to measuring mode.
NOTES When readings are deleted, the statistics will be upgraded automatically.
5.1.10. High and Low Limit Alarm
Each group has individual high/low limit alarm settings. When switching to the work group, the
applied alarm settings will also be switched automatically.
t 4FUIJHIMPXMJNJUGPSUIFDVSSFOUXPSLHSPVQBTCFMPX
a. Press “Left Key” once to enter into menu mode (”Root” directory);
b. Press “Up Key” or “Down Key” to activate “Limit”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate “Settings”, and press “Left Key” once to enter
d. Press “Up Key” or “Down Key” to activate your intended item, and press “Left Key” once
to enter
e. Press “Up Key” or “Down Key” to increase or decrease the limit value. If the key is hold, the
limit value will be increased or decreased continuously.
f. Press “Left Key” to conrm new limit value, or “Right Key” to cancel and go back. Press
“ZERO Key” to go back to measuring mode.
t $MFBSIJHIMPXMJNJU
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Limit”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate “Clear”, and press “Left Key” once. A dialog box
will be displayed.
d. Press “Left Key” once to conrm the selection and go back, or “Right Key” to cancel and go
back. Press “ZERO Key” to go back to the measuring mode.
NOTES When readings exceed the high limit, the alarm symbol will appear on the LCD, and
when readings exceed the low limit, the alarm symbol will appear.
EN