To Next PageTo Next Page
Need help?Do you have a question about the Tracerco Profiler T229-2 and is the answer not in the manual?
General| Brand | Tracerco |
|---|---|
| Model | Profiler T229-2 |
| Category | Controller |
| Language | English |
Details of parties to be notified on revision release.
Tracerco contact details for operational queries and emergency numbers.
Explains the core measurement principle of the Profiler.
Describes the physical layout and detector setup.
Guidance on installing the profiler unit and its components.
Procedure for ensuring secure bolt connections.
Safety procedures for handling radioactive sources and access.
Specific safety notes for the Cesium variant.
Information on module connections and terminal functions.
Explanation of the module's LED status indicators.
Procedure for accessing and logging into the software.
Steps to load backup configuration files.
Introduction to the Calibrator tool's capabilities.
Overview flowchart for setting up the instrument.
Setting network and measurement unit parameters.
Configuring the instrument's date/time and identification tag.
Verifying communication settings for Modbus.
Defining source type and operational measurement range.
Configuring signal filtering and pressure compensation.
Setting density correction and phase density bands.
Setting up devices, including fault handling.
Setting temperature operational limits.
Arranging sensors and configuring incoming count filtering.
Configuring sensor dead time parameters.
Defining stage elevations and saving settings.
Step-by-step guide for instrument calibration.
Setting reference densities and gathering calibration counts.
Finalizing calibration date and saving parameters.
Setting up alarms and fault handling logic.
Configuring criticality for stages and alarms.
Configuring the analogue input channel.
Configuring analogue output channels.
Various modes for analogue output configuration.
Configuring fault indication on analogue output.
Adjusting output signal behaviour.
Configuring digital output signals.
Modes for digital output configuration.
Mapping Modbus registers for data output.
Functionality of the command tool.
Advanced density correction features.
Selecting phases and calculating average density.
Details on wiring and safety for intrinsically safe systems.
Specific precautions for safe operation and handling.
Step-by-step guide for replacing a processor board.
Scheduled maintenance tasks and checks.
Electrical supply and fibre optic setup for the T240.
Detailed specifications for system components.
Specs for performance, dip pipes, sources, and detectors.
Environmental and physical specifications.
Power/fibre optic cable specs and supply details.
Compliance with industry standards and certifications.
Detailed register map for the T229 controller.
Explanations of various register functions and their uses.
