10
18-GJ11D1-2
STEP 15. Attach the two supplied screws through the holes in the
bracket. Use a low torque setting when drilling in screws.
IMPORTANT: Use the provided cable ties to secure the wires
behind the cross bar.
Installing UV Lamp wiring connections
NOTE: If the coil was removed before installation, replace the coil
before continuing with the kit installation.
STEP 16. Install the left and right side lamps and reflectors into
their brackets.
IMPORTANT: The lamp is held in place by a metal reflector that
is slightly elliptical. You may need to rotate the lamp when sliding
it into the bracket. The lamp will slide in easily once properly
aligned.
To Next Page
Loading...