18-GJ89D1-1D-EN
27
10. Replace the Line Set panel.
a. Allow time for tubing to cool.
b. Install grommets to line set piping in orientation shown.
Note: A slight amount of dish soap can be used to aid in the
installation of the grommets. Remove any excess from the
tubing and grommet after the grommet is installed.
c. Slide the bottom of the Line Set panel down over the
refrigerant lines and grommets. The grommets will seal the
line openings.
d. Tighten screws on the Line Set panel.
SEE ENLARGED ILLUSTRATION FOR ORIENTATION
RReeffrriiggeerraanntt LLiinnee BBrraazziinngg
To Next Page
Loading...
