Handling Alarms and Events
122 BMTX-SVU01B-EN
Figure 108. Requesting Alarms from the BCU Local Event Log
Refreshing the Event Log
You can update your event log to display new alarms and events by using
the refresh feature.
You can refresh the event log either automatically or manually. The Auto
Refreshing feature is enabled by default. If the Auto Refreshing feature is
enabled, an event displays automatically when it arrives in the worksta-
tion within the time interval specified in the System Options utility.
You can manually refresh the event log by clicking the Refresh button.
You can manually refresh when the Auto Refreshing feature is enabled.
You can disable or re-enable the Auto Refresh feature at the General tab
in the System Options utility. For more details, see the system options
chapter in the Tracer Summit System Programming guide.
Click Go to request new alarms
Note:
Automatic refreshing is not supported for the BCU Event Log
and the Error Log.
To Next Page
Loading...
