Trane TRACER SUMMIT BMTX-SVU01B-EN - Running Reports

Filtering the Event Log
BMTX-SVU01B-EN 129
To save a filter:
◆ Click the Set as Default Filter button (see Figure 117)..
Setting up a Default Filter
You can setup a default filter in the event log or BCU event log. It is saved
after you exit the site.
1. Select the criteria that you want displayed in your default filter as
explained in “Filtering the Event Log” on page 127.
2. Click on the Set as Default Filter button (see Figure 117). The button
grays out, which confirms that the displayed filter is setup as the
default filter.
Figure 117. Default Filter Button
3. Click Close. The default filter is automatically saved.
3 Status Allows you to filter by status. The default selection is Acknowledge Required (Ack
Req).
4 Event Type Allows you to filter the event log to display a particular type of alarm or
event.This field is enabled when you select Choose Type from the Status drop-
down list.
5 (Unlabeled) This grey field appears below the other fields and shows the number of alarms
and events that match your selections.
Table 7. Filter Selection Criteria
Item Title Description
Note:
New alarms do not display unless they match the filter criteria.
To view new alarms, uncheck the Enable Filtering option. If you
are filtering at the BCU Event Log tab, click the Go button to
add new alarms.
Set as Default Filter button