Using the Tutorial as a Stand-alone Training Course
BMTX-SVU01B-EN 21
Using the Tutorial as a Stand-alone
Training Course
As a stand-alone training course, the Daily Operations Tutorial offers you
an opportunity to gain basic skills in operating a Tracer Summit system.
The training course parallels the information in the Tracer Summit Daily
Operations guide and focuses on the basic daily tasks you will need to
perform. Since the stand-alone training course is run entirely from the
Daily Operations Tutorial CD-ROM, it is not necessary to have Tracer
Summit installed.
Accessing the Stand-alone Tutorial
After you have installed the tutorial on your PC, a Tracer Summit Tuto-
rial icon is automatically placed on your Windows desktop. (Installation
instructions are included in the tutorial CD-ROM case and in the Hard-
ware and Software Installation guide.) To run the tutorial program, you
must have the Daily Operations Tutorial CD-ROM in the CD-ROM drive
of your PC.
To access the tutorial:
1. Double-click the Tracer Summit Tutorial icon. The tutorial opens and
the logon dialog box is displayed.
2. In the User ID field, type a user ID. (The User ID can be anything you
want.)
3. In the Password field, type a password. (The password can be any-
thing you want.)
4. In the Verify field, type the password again and press the Enter key.
The Daily Operations Tutorial Main Menu displays (see Figure 18 on
page 22).
For the tutorial to keep track of which modules have been completed, you
must log on to the tutorial with the same user name and password each
time you run the tutorial.
Note:
If you are entering a new user name and password for the first
time, a message box is displayed asking you to confirm that this
is your first visit to the course. If this is not your first visit,
recheck your user name and password.
Note:
Each user should set up his or her own user name and pass-
word for running the tutorial.
To Next Page
Loading...
