Finding Your Way Around
36 BMTX-SVU01B-EN
The navigation tree can show all the system and site objects in the data-
base. The navigation tree is shown in Figure 31.
Click this button once to display the Trend Viewer. The
Trend Viewer object must be set up before it can be viewed.
If you are unable to view the Trend Viewer, see your Sys-
tems Administrator.
Click this button once to display the alarm and event log.
For more information about using this screen, see Chapter
9, “Handling Alarms and Events.”.
Click this button once to display the navigation tree. Click it
again to hide the navigation tree. For more information
about the navigation tree, see the section “For more infor-
mation about the task bar, see Table 2.Navigation Tree” on
page 35.
Click this button once to connect to the site. For more infor-
mation about using the site connection wizard, see the
Tracer Summit System Programming guide.
Click this button once to disconnect from the site. For more
information about disconnecting from a site, see the Tracer
Summit System Programming guide.
Click this button once to initiate or cancel a timed override
request for an area. When the workstation is not online with
the BCU, this button is not available.
Click the Alarms Category button(s) to display the Event
Log. This button only displays when it is set up in the Sys-
tems Options dialog box (Tools>Options).
The alarm status button has a drop-down list and is associ-
ated with the Alarms Category button. From this list you
can select all of the alarms in an alarm category, all unac-
knowledged (UnAck) alarms in an alarm category, or none of
the alarms for an alarm category.
This is another alarm status button that has a drop-down
list, and is associated with the Alarms Category button.
From this list you can select to view category alarms in the
current site, a different site, or all sites.
Table 2. Task Bar Descriptions (Continued)
Button Task Completed
To Next Page
Loading...
