Trane TRACER SUMMIT BMTX-SVU01B-EN - Overriding a Multi-State Output in a Non-Trane Bacnet Device

Displaying and Changing Status Information
66 BMTX-SVU01B-EN
3. Click and drag the indicator in the slider bar to the desired setting.
4. Click the Apply button to apply the override and view the results, or
click OK to apply the changes and close the dialog box.
To return control back to the BAS, see “Releasing Control Back to the Sys-
tem” on page 71.
Overriding a Multi-State Output in a non-Trane BACnet
Device
1. Open the Simplified Override dialog as described in “Accessing the
Simplified Override Dialog box” on page 60. The Override dialog box
displays (see Figure 58).
Figure 58. Non-Trane Analog Output (Multi-state) Override Dialog Box
2. Verify that the Control knob is in the Change to position.
3. Click and drag the indicator in the slider bar to the desired setting.
Note:
Click on the More control button at the bottom of the dialog box
to display the Priority Arrays box. To perform an override, your
default control priority level must be higher than priority level
listed in the box. If not, refer to “Using the Advanced Systems
Override” on page 72.