Trane TRACER SUMMIT BMTX-SVU01B-EN - Overriding a Binary Output or Binary Value in a Non-Trane Bacnet Device

Displaying and Changing Status Information
68 BMTX-SVU01B-EN
3. Click the toggle switch to set it to the On state, or click the toggle
switch to set it to the Off state. With either selection, the On label or
the Off label will then appear in bold.
4. Click the Apply button to apply the override and view the results, or
click OK to apply the changes and close the dialog box.
To return control back to the BAS, see “Releasing Control Back to the Sys-
tem” on page 71.
Overriding a Binary Output or Binary Value in a
Non-Trane BACnet Device
1. Open the Simplified Override dialog as described in “Accessing the
Simplified Override Dialog box” on page 60. The Override dialog box
displays (see Figure 60).
Figure 60. Non-Trane binary Output Override Dialog Box
Note:
The toggle switch labels are defined in the Binary Output
editor and can be assigned names other than On and Off.