Changing Schedules
86 BMTX-SVU01B-EN
Displaying the Daily Events in a
Schedule
When you display a schedule, the events for the current day are displayed
as time bars. You can identify the type of event by holding the mouse over
the time bar.
To identify the event type:
1. Move the mouse pointer to the event time bar you want to identify
(see Figure 73).
2. Wait 1–2 seconds (do not click the mouse button). A small window
containing a description of the event displays next to the time bar.
Figure 73. Identifying the Event Type
About Event Time Bars
An event time bar includes the following information:
• The start time is designated with a green dot on the event time bar.
• The stop time is designated with a red dot on the event time bar.
• Optimal start/stop events have a cross-hatched area showing the ear-
liest start time. For example, if the optimal start time is set for 7 a.m.
with an early limit of 120 minutes, the earliest time for the start com-
mand is 5 a.m. The area between 5 a.m. and 7 a.m. is shown on the
time bar as a cross-hatched area.
Position pointer over
time bar and wait
1–2 seconds for the
event description to
display (do not click
mouse button)
Event description
Cross-hatched area
shows earliest start
time for optimum start
Note:
You cannot drag the end bars to change the event’s time. For
information on changing event times, refer to “Changing Start
or End Times of Events” on page 88.
To Next Page
Loading...
