BAS-SVX46E-EN
23
• Set a unique and valid rotary switch address for each device (“Setting rotary switches,” p.
14).
To configure the expansion modules:
1. Apply power to the UC400 or UC600, the expansion modules, and the PM014 power supply
module (if applicable).
2. Verify that all expansion modules are powered up by observing the (RX) LEDs, which blink
when communication occurs between the devices. See Table 9, p. 24.
3. Open the Tracer TU
™
service tool and establish a direction connection to the UC400 or UC600
by using a USB cable or a BACnet link discovery.
4. From the Utilities menu, click Utilities/Status/Controller settings.
5. Open the Expansion Module group box.
6. From the AAdddd ddrroopp--ddoowwnn list, select the module you want to add and then click Go. Only one
module can be selected at a time. This populates a table containing the modules (Figure 15,
p. 23).
7. Verify that the correct address is displayed for each module in the AAddddrreessss field. If not, set
the appropriate rotary addresses. A rotary dial setting of 0011 eeqquuaallss 11 in the AAddddrreessss field. For
help refer to “Troubleshooting,” p. 25.
8. Click the SSeenndd ttoo DDeevviiccee button.
9. This action saves the configuration to the controller and initiates discovery on the IMC link.
The TX/RX LEDs on the expansion module will blink when the IMC communication to the
expansion module is configured. Tracer TU displays DDeevviiccee DDiissccoovveerryy CCoommpplleettee when the
discovery process is complete.
NNoottee:: You can continue to add additional modules as described in the above procedure. The total
number of terminations on a UC600 link cannot exceed 120. For example, if you reached
119 terminations, additional modules cannot be added because expansion modules have
four or more terminations (all terminations on a module are accounted for).
Figure 15. Expansion modules group box (Tracer TU)
IInnssttaalllliinngg tthhee TTrraacceerr EExxppaannssiioonn MMoodduulleess
To Next Page
Loading...
