7-12 DSCP Remarking
Use the Queues to DSCP page to remark DSCP value for egress traffic from each queue.
Web Interface
To configure the DSCP Remarking in the web interface:
1. Click Quality of Service and DSCP Remarking.
2. Select DSCP.
3. Click the Apply button to save the setting.
4. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 7-12: The QoS Egress Queue to DSCP Remarking
Parameter descriptions:
Queue ID: Displays the Queue ID, where Queue 8 is the highest priority egress queue and
Queue 1 is the lowest priority egress queue.
DSCP: For each output queue, select the DSCP priority to which egress traffic from the
queue is remarked. For example Expedited Forwarding (EF) for low-loss, low-latency traffic
or Assured Forwarding (AF) which assures delivery under prescribed conditions.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...