8-2 Region Config
The section describes how to configure the basic identification of a MSTP bridge. Bridges
participating in a common MST region must have the same Region Name and Revision Level.
Web Interface
To configure the Region Config in the web interface:
1. Click Spanning Tree and Region Config.
2. Specify the Region Name and Revision Level.
3. Click the Apply button to save the setting.
4. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 8-2: MSTP Region Config
Parameter descriptions:
Region Name (0~32 characters): The name identifying the VLAN to MSTI mapping. Bridges must
share the name and revision (see below), as well as the VLAN-to-MSTI mapping configuration in order
to share spanning trees for MSTI's (Intra-region). Enter up to 32 characters.
Revision Level (0-65535): The revision of the MSTI configuration named above. This must be an
integer between 0 and 65535.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...